Skip to content
Hydrosta Kazakhstan
Service 03

Commissioning

An installed system and a working system are not the same thing. Commissioning brings the equipment to its design parameters and proves it with measurements.

Deliverables

What you receive

Not “work completed”, but specific documents and a system state you can verify.

01

Test reports

Pressure test, flushing, aerodynamic and hydraulic tests with actual measured values.

02

Balanced system

Flows on every branch and loop set to the design — not “however it turned out”.

03

Configured controls

Weather compensation, schedules, priorities, alarm scenarios.

04

Staff training

Briefing for the operating staff and an operating guide for everyday regimes.

Process

How the work proceeds

  1. Readiness checkInspection of the installed systems, cross-check against the design, resolving snags before start-up.
  2. Individual testsChecking each component separately: pumps, burners, fans, controls, safety devices.
  3. Integrated start-upSystems operating together under load, measurements and branch-by-branch balancing.
  4. HandoverIssuing test reports, handing over as-built documentation, signing the acceptance certificates.
Systems

Which systems

The service applies to all six disciplines — the scope of work changes, the process stays the same.

Frequently asked questions

Questions about this service

Yes. Without balancing some rooms are underheated and others overheated at the same gas consumption. The difference between “works” and “works to design” shows up in the bills.

Need “commissioning”?

Site visit, measurements and a technical brief. You receive an itemised estimate and a system layout.

Free consultation

We will call you back

Leave your name and phone number and we will call you during business hours. The consultation is free.

We use your name and phone number only to call you back.